Shutter Dog Installation

This guide covers the installation of the Colonial Shutter Dog (part #: WD-104),
the Clam Shell Shutter Dog (part#: CD-105) and the "S" Shutter Dog (part#: SD-103).
The installation of the Colonial Shutter Dog is shown in this guide. The "S" Shutter Dog and
the Clam Shutter Dog are installed using the same procedure as the Colonial Shutter Dog.
 

Step 1: Place shutter dog hardware on bottom edge of shutter, approximately 2" from outer edge of shutter. While holding the shutter dog hardware in place, drill a 3/16" hole through shutter dog flange and shutter.
Step 2: While holding the shutter dog hardware in alignment with the newly drilled hole, insert the plastic "push fastener" in the hole of the shutter dog and then through the hole in the shutter.
Congratulations: Your new shutter dog should now be properly installed. Please check the photo to see if your installation was a success.



Your IP Address is: 54.156.76.187
Copyright © 2018 Classic Accents Hardware. Powered by Zen Cart