Hinge Installation

This guide covers the installation of the Strap Hinge (part #: SH-107) and the Butt Hinge (part#: BH-108).
The installation of the Strap Hinge is shown in this guide. The Butt Hinge is installed using the same procedure as the Strap Hinge.

Step 1: Pick up one hinge and two metal clips.

Step 2: Place metal clip in each rectangular slot on the hinge. Make sure the hole of the metal fastener is facing the hole of the hinge. Make sure the points are facing up on the hinge. Slide the assembled hinge into the inside edge of the shutter. The metal clips will hold the hinge in place.
If you have wood shutters, the hinge can be installed using a wood screw (not provided) instead of the metal clips.
Congratulations: Your new hinge hardware should now be properly installed. Please refer to the picture below to see if your installation was a success.
Your IP Address is: 54.198.243.51
Copyright © 2018 Classic Accents Hardware. Powered by Zen Cart