Ring Installation

This guide covers the installation of the ring hardware (part #: PR-106).

Step 1: Pick a spot you prefer on the shutter next to the outer edge. Measure where the hole should be drilled on the shutters. Drill a 3/16" hole on each shutter using the measurements.

Step 2: Align small hole on ring hardware with drilled hole in shutter. Insert plastic "push fastener" in the small hole of the ring hardware. Firmly push in plastic "push fastener". To avoid shutter damage, do not use excessive force.
Congratulations: Your new ring hardware should now be properly installed. Your ring hardware should look like the picture below.
Your IP Address is: 54.196.190.32
Copyright © 2018 Classic Accents Hardware. Powered by Zen Cart